Using the Imagesetter Control Panel 2–21
Selecting and Canceling Pause Pending Mode
n To enter Pause Pending mode, press Pause on the Run screen
while the imagesetter is busy.
n The Pause button blinks to indicate Pause Pending.
n When the current job is finished, the Pause screen appears. You
can perform media operations, check parameters, etc.
n Press Run to resume imaging. If jobs were left in the queue when
the imagesetter went into Pause mode, the imagesetter continues
where it left off.
n To cancel Pause Pending, press the Pause button while it is
blinking. The blinking stops.
To Next Page
