Using the Imagesetter Control Panel 2–55
Plate Exposure Area: The imagesetter exposes the pages you send from
your front-end application on an area of the plate material. The
imagesetter can expose some additional sections of the plate material
as follows. See Figure 2.27 for illustrations of the plate exposure icons.
n No additional area
n An area to the left and right of the page
n An area to the left and right of the page as well as the punch area
Figure 2.27 Plate Exposure icons. ➀—No additional area.
➁—An area to the left and right of the page.
➂—An area to the left and right of the page as well as the punch area.
Output Mode: Use this function to change from on-line processing to
off-line processing.
Viewing Angle: Use this function to change the contrast of the
control panel screen for better viewing. The optimum setting is a
matter of personal preference.
Volume: Use this function to change the volume of the control panel
speaker.
Auto Dial Out: Use this function to turn Auto Dial Out on or off. A
modem must be attached to the phone line for Auto Dial Out to be on.
Humidifier: Use this function to turn the Humidifier On or Off.
PL
PL PL
➀
➂
➁
To Next Page
Loading...
Need help?
General
