7- 57
Operating Concepts
Modifying Calibration Kits
Modifying Calibration Kits
Modifying calibration kits is necessary only if unusual standards (such as in TRL*) are used or the very
highest accuracy is required. Unless a calibration kit model is provided with the calibration devices used, a
solid understanding of error-correction and the system error model are absolutely essential to making
modifications. You may use modifications to a predefined calibration kit by modifying the kit and saving it as
a user kit. The original predefined calibration kit will remain unchanged.
Before attempting to modify calibration standard definitions, you should read Application Note 8510-5A to
improve your understanding of modifying calibration kits. The part number of this application note is
5956-4352. Although the application note is written for the 8510 family of network analyzers, it also applies
to this network analyzer.
Several situations exist that may require a user-defined calibration kit:
• A calibration is required for a connector interface different from the four default calibration kits.
(Examples: SMA, TNC, or waveguide.)
• A calibration with standards (or combinations of standards) that are different from the default calibration
kits is required. (Example: Using three offset shorts instead of open, short, and load to perform a 1-port
calibration.)
• The built-in standard models for default calibration kits can be improved or refined. Remember that the
more closely the model describes the actual performance of the standard, the better the calibration.
(Example: The 7 mm load is determined to be 50.4
instead of 50.0 .)
Definitions
The following are definitions of terms:
• A "standard" (represented by a number 1-8) is a specific, well-defined, physical device used to determine
systematic errors. For example, standard 1 is a short in the 3.5 mm calibration kit. Standards are
assigned to the instrument softkeys as part of a class.
• A standard "type" is one of five basic types that define the form or structure of the model to be used with
that standard (short, open, load, delay/thru, and arbitrary impedance); standard 1 is of the type short in
the 3.5 mm calibration kit.
• Standard "coefficients" are numerical characteristics of the standards used in the model selected. For
example, the offset delay of the short is 32 ps in the 3.5 mm calibration kit.
• A standard "class" is a grouping of one or more standards that determines which of the eight standards
are used at each step of the calibration. For example, standard number 2 and 8 usually makes up the
S
11
A reflection class, which for type-N calibration kits are male and female shorts.
To Next Page
Loading...
Need help?
General
