1-28
Making Measurements
Using Markers
Figure 1-15 Marker Information on the Graticules
You can also restore the softkey menu by pressing a hardkey which opens a menu (such as ) or
pressing a softkey.
To Use Delta () Markers
This is a relative mode, where the marker values show the position of the active marker relative to the delta
reference marker. You can switch on the delta mode by defining one of the five markers as the delta
reference.
1. Press to make marker 1 a reference marker.
2. To move marker 1 to any point that you want to reference:
• Turn the front panel knob.
OR
• Enter the frequency value (relative to the reference marker) on the numeric keypad.
3. Press and move marker 2 to any position that you want to measure in reference to
marker 1.
To Next Page
Loading...
Need help?
General
