Agilent Technologies U1602B - Page 26

xxvi Agilent U1602B/U1604B User’s and Service Guide
Figure 3-10. The waveform before inversion. 34
Figure 3-11. The waveform after inversion 35
Figure 3-12. Time/div display in status line 36
Figure 3-13. Changing time base of a waveform 37
Figure 3-14. Select time reference 39
Figure 3-15. XY format display 40
Figure 3-16. When Window function is turned on, a zoom area
selection bar appears at the center of the display. Adjust
rotary switch clockwise to expand the zoom area. 41
Figure 3-17. Press F1 to enable zooming function 42
Figure 3-18. Normal trigger mode 43
Figure 3-19. Normal acquisition mode 53
Figure 3-20. Average acquisition mode 54
Figure 3-21. Peak Detection Mode 54
Figure 3-22. Dots display type 55
Figure 3-23. Vectors display type 56
Figure 3-24. Select automatic measurement for the Measure 1
file. 60
Figure 3-25. +Width and –Width measurements 61
Figure 3-26. Period measurement 62
Figure 3-27. Voltage measurement 63
Figure 3-28. Phase measurement 64
Figure 3-29. Delay measurement 64
Figure 3-30. Cursor measurement menu 66
Figure 3-31. X-cursor measurement for channel 1 signal with X1
and X2 cursor lines 68
Figure 3-32. X-cursor measurement for channel 2 signal with X1
and X2 cursor lines 69
Figure 3-33. Math functions for X-cursor measurement 69
Figure 3-34. Y-cursor measurement for channel 1 signal with Y1 and
Y2 cursor lines 71
Figure 3-35. Y-cursor measurement for channel 2 signal with X1 and
X2 cursor lines 72
Figure 3-36. Math function for Y-cursor measurement 72