Agilent U1602B/U1604B User’s and Service Guide ix
General Safety Information
The following general safety precautions must be observed during all
phases of operation, service and repair of this instrument. Failure to
comply with these precautions or with specific warnings elsewhere in this
manual violates safety standards of design, manufacture and intended use
of the instrument. Agilent Technologies assumes no liability for the
customer’s failure to comply with these requirements.
• All DMM/Scope COM are internally connected. Only connect
DMM/Scope COM to same potential.
• Remove all unused scope probes and test leads.
• Do not connect DMM test leads and scope probes at the same time.
• Disconnect scope probe from instrument before using DMM
functions.
• Disconnect DMM test leads from instrument before using scope
functions.
To avoid electrical shock or fire during battery replacement:
• Disconnect test leads, probes and power supply before opening case
or battery door.
• Do not operate the instrument with battery cover open.
• Use only specified insulated probes and leads.
• Use only U1571A, 7.2 V Ni-MH battery pack supplied by
manufacturer.
To Next Page
Loading...
