Getting Started 1
Agilent U1602B/U1604B User’s and Service Guide 5
To Charge a Battery
✔ Before using the instrument for the first time, fully charge the battery
for approximately 25 hours with the unit turned on by using the
designated Agilent AC adapter. Ensure that you have the correct line
power cord (refer to Table 1- 1). The AC adapter automatically converts
input line voltage ranges from 100 VAC – 240 VAC, 50/60 Hz to output
voltage 12 VDC, 2 A.
A new rechargeable battery comes in a discharged condition and must
be charged before use. Upon initial use (or after a prolonged storage
period) the rechargeable battery may require three to four
charge/discharge cycles before achieving maximum capacity. To
discharge, simply run the oscilloscope under the rechargeable battery's
power until it shuts down or until you get a low battery warning.
To avoid instruments being damage from battery leakage, always remove dead
batteries immediately.
For quick charging mode with instrument turned off, the charging time is approximately 4.5
hours.
To Next Page
Loading...
