E16 Door Phone Administrator Guide
Note
•
IR LED light should be triggered first before the white light can be valid in the
facial recognition, however, IR LED light does not need to be triggered for the
white light function in the QR code scan.
•
Mode: if you select Auto, then the white light will be turned on automatically for face
recognition and QR code scan for door opening. If you select Off, then the white light
will be disabled.
•
Max White Light Value: set the white light value from1-5, and the default white light
value is 3. The greater value it is, the brighter the light will be.
5.4
Screen Display configuration
E16 series door phones allow you to enjoy a variety of screen displays to enrich your visual
and operational experience through the customized setting to your preference.
5.4.1
Configure Screensaver
Await screen is mainly a function for screen protection. You can make the device go into
idle status for a predefined time span when there is no operation on the device, or no one
is detected approaching. To configure the configuration on web Device > LCD >
Standby Interface Display interface.
Parameter Set-up:
•
ScreenSaver Mode: tick the check box to enable the screen saverfunction.
To Next Page
Loading...
