E16 Door Phone Administrator Guide
Note
•
Disarm tab will turn gray when the temper alarm iscleared.
•
The round rubber button at the back of the device must be in press-down
status otherwise the alarm will not be fired.
12 Security
12.1
Tamper Alarm Setting
The tamper alarm function serves as a protection against any unauthorized removal of the
device by triggering off the temper alarm on the device. To configure the configuration on
web Security > Basic > Temper Alarm interface.
Parameter Set-up:
•
Enable: tick the check box to enable the temper alarm function. When the temper
alarm goes off, you can press the Disarm tab beside the check box to clear the
alarm.
•
Key Status: when the tamper alarm button pops up, then the status will be changed
from low to high. The normal state is high.
To turn on the tamper-proof function on the device, tap Security > Temper Proof.
To Next Page
Loading...
