Akuvox E16C User Manual

www.akuvox.com
E16 Door Phone Administrator Guide
56
11.3.3 Configure RF Card Code Format
If you want to integrate with the third-party intercom system in terms of RF card door
access, you can change the RF card code format to be identical to that applied in the third-
party system. To configure the configuration on the web Access Control > Card
Setting interface.
Parameter Set-up:
• IC-Card Display Mode: select the card format for the ID Card for the door access
among five format options: 8H10D; 6H3D5D(W26); 6H8D; 8HN; 8HR. The card code
format is 8HN by default in the door phone.
11.4 Configure Facial Recognition for Door Unlock
11.4.1 Enroll Face Data on the Device
You can configure door access by facial recognition on the device by entering the user’s
name and registering your facial ID on the device for door access. Tap User > User
List, then tap Add, and tap Face.

Akuvox E16C Specifications

General

Color	Yes
Speakerphone	No
Connectivity technology	Wired
Number of displays supported	-
Display diagonal	5 \
Display resolution	1280 x 720 pixels
Display technology	IPS
Proper use	Indoor
Product color	Black
Housing material	Plastic
International Protection (IP) code	IP65
Networking standards	IEEE 802.3af
Ethernet LAN data rates	10, 100 Mbit/s
Ethernet LAN (RJ-45) ports	1
Megapixel	2 MP
Indoor unit power type	DC
Operating temperature (T-T)	-20 - 60 °C
Operating relative humidity (H-H)	10 - 90 %
Quantity per pack	1 pc(s)
Operating system installed	Linux

Weight and Dimensions

Depth	27.5 mm
Width	88 mm
Height	192 mm