E16 Door Phone Administrator Guide
Note
•
The general configuration file for the in-batch provisioning is with the format
rcfg taking E16 as an example r000000000116.cfg ( 9 zero in total while the
MAC-based configuration file for the specific device provisioning is with the
format MAC_Address of the device.cfg), for example, 0C110504AE5B.cfg.
•
DHCP Option 66: if none of the above is set, the device will automatically use DHCP
Option 66 for getting the upgrade server URL. This is done within the software and
the user does not need to specify this. To make it work, you need to configure the
DHCP server for option 66 with the updated server URL init.
•
DHCP Option 43: if the device does not get an URL from DHCP Option 66, it will
automatically use DHCP Option 43. This is done within the software and the user
does not need to specify this. To make it work, you need to configure the DHCP
server for option 43 with the updated server URL in it.
18.6
Static Provisioning Configuration
You can manually set up a specific server URL for downloading the firmware or
configuration file. If an autop schedule is set up, the door phone will perform the auto-
provisioning on a specific timing according to autop schedule you set up. In addition,
TFTP, FTP, HTTP, and HTTPS are the protocols that can be used for upgrading the device
firmware and configuration. To download the Autop template on System > Auto
Provisioning > Automatic Autop, and setup Autop server on System > Auto Provisioning >
Manual Autop interface.
To Next Page
Loading...
