E16 Door Phone Administrator Guide
15 Debug
15.1
System Log for Debugging
System log in the access control terminal can be used for debugging purposes. If you want
to export the system out to a local PC or to a remote server for debugging, you can set up
the function on the web System > Maintenance > System Log interface.
Parameter Set-up:
•
Log Level: select log levels from 1 to 7 levels. You will be instructed by Akuvox
technical staff about the specific log level to be entered for debugging purposes. The
default log level is 3, the higher the level is 5, the more complete the log is 7.
•
Export Log: go to the Export tab to export a temporary debug log file to a local PC.
•
Remote System Log Enabled: select Enable or Disable if you want to enable or
disable the remote system log.
•
Remote System Server: enter the remote server address to receive the device log.
15.2
PCAP for Debugging
PCAP is used to capture the data package going in and out of the devices for debugging
and troubleshooting purposes. You can set up the PCAP on the device web System >
Maintenance > PCAP properly before using it.
To Next Page
Loading...
