E16 Door Phone Administrator Guide
Parameter Set-up:
•
Name: check to select the H264 video codec format for the door phone video H264
is the video codec by default.
•
Resolution: select the code resolution for the video quality among four options:
QCIF, CIF, VGA, 4CIF, and 720P according to your actual network environment. The
default code resolution is 4CIF.
•
Bitrate: select the video stream bit rate (ranging from 320-2048). The greater the
bitrate, the data transmitted every second is greater in amount therefore the video
will be clearer. While the default code bitrate is 2048.
•
Payload: select the payload type (ranging from 90-118) to configure the audio codec
payload. The payload between the door phone and the corresponding intercom
device should be identical. The default payload is 104.
7.7
Configure DTMF Data Transmission
In order to achieve door access via DTMF code or some other applications, you are
required to properly configure DTMF in order to establish a DTMF-based data transmission
between the door phone and other intercom devices for the third-party integration. To
configure the DTMF data transmission, you can go to Account > Advanced > DTMF.
To Next Page
Loading...
