E16 Door Phone Administrator Guide
Parameter Set-up:
•
Server Mode: it is automatically set up according to the actual device connection
with a specific server in the network such as SDMC, ACMS Cloud, and None. None is
the default factory setting indicating the device is not in any server type, therefore
you are allowed to choose Cloud, SMDC in discovery mode.
•
Discovery Mode: go to Enabled to turn on the discovery mode of the device so that it
can be discovered by other devices in the network, and go to Disabled if you want to
conceal the device so as not to be discovered by otherdevices.
•
Device Address: specify the device address by entering device location information
from the left to the right: Community, Unit, Stair, Floor, Room in sequence.
•
Device Extension: enter the device extension number for the device you installed.
•
Device Location: enter the location in which the device is installed and used.
6.3
NAT Setting
Network Address Translation (NAT) is what is used to map multiple local private
addresses to legal public ones before transferring the information. To facilitate data
transmission between the door phone and the SIP server, you will need to set up NAT. You
can go to Account > Advanced > NAT.
Parameter Set-up:
•
UDP Keep Alive Messages: if enabled, the device will send out the message to the
SIP server so that the SIP server will recognize if the device is in online status.
•
UDP Alive Msg Interval: set the message sending time interval from 5-60 seconds,
the default is 30 seconds.
To Next Page
Loading...
