E16 Door Phone Administrator Guide
•
Enabled: it is enabled by default.
•
Trigger Electrical Level: select the trigger electrical level options betweenHigh
and Low according to the actual operation on the exit button.
•
Action to Execute: select the method to carry out the action among four options:
FTP, Email, HTTP, and TFTP.
•
HTTP URL: enter the URL if you select the HTTP to carry out the action.
•
Action Delay: set up the delay time when the action is carried out. For example, if you
set the action delay time at 5 seconds, then the corresponding actions will be carried
out 5 minutes after you press the button(input istriggered).
•
Action Delay Mode: if you select Unconditional Execution, then action will be carried
out when the input is triggered. If you select Execute If Input Still Triggered, then the
action will be carried out if the input stays triggered. For example, if the door stays
open after triggering input, an action such as an email will be sent to notify the
receiver.
•
Execute Relay: set up relays to be triggered by the input.
•
Door Status: display the status of the input signal.
11.10
Unlock by Reception Tab
On the device's home screen, the E16 series door phone provides residents and visitors
quick door access by pressing the Reception tab at the bottom of the home screen. To do
the configuration, you can go to Intercom > Basic > Key Setting.
Parameter Set-up:
•
Reception Enabled: tick the check box to enable the function.
To Next Page
Loading...
