E16 Door Phone Administrator Guide
•
AuthorizationEnabled: tick the check box to enable the RTSP authorization. If you
enable the RTSP Authorization, you are required to enter RTSP Authentication Type,
RTSP Username, and RTSP Password on the intercom device such as an indoor
monitor for authorization.
•
Authentication Mode: select RTSP authentication type between Basic and Digest.
Basic is the default authentication type.
•
Username: enter the name used for RTSP authorization.
•
Password: enter the password for RTSP authorization.
13.3.2
RTSP Stream Setting
You can select the video codec format for the RTSP stream for the monitoring and you can
also configure video resolution and bitrate etc. based on your actual network environment
on the web interface. To configure the configuration on web Surveillance > RTSP > H.264
Video Parameters interface.
Parameter Set-up:
•
Video Resolution: select video resolutions among seven options: QCIF, QVGA, CIF,
VGA, 4CIF, 720P, and 1080P. The default video resolution is 720P, and the video
from the door phone might not be able to be shown on the indoor monitor if the
resolution is set higher than 720P.
•
Video Framerate: 25fps is the video frame rate by default.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
