E16 Door Phone Administrator Guide
13 Monitor and Image
13.1
MJPEG Image Capturing
E16 series allows you to capture the MJPEG format monitoring image if needed. You can
enable the MJPEG function and set the image quality on the web interface. To configure
the configuration on web Surveillance > MJPEG > MJPEG Server interface.
Parameter Set-up:
•
Enabled: tick the check box to enable or disable the Mjpegservice.
•
Image Quality: select the quality for the image capturing among seven options: QCIF,
QVGA, CIF, VGA, 4CIF, 720P, 1080P
After the MJPEG service is enabled, you can capture the image from the door phone using
the following three types of URL format:
•
http:// device ip:8080/picture.cgi
•
http://deviceip:8080/picture.jpg
•
http://deviceip:8080/jpeg.cgi
For example, if you want to capture the jpg format image of a door phone with the IP
address: 192.168.1.104, you can Enter “http://192.168.1.104:8080/picture.jpg” on the web
browser.
You can also enable the MJPEG server on the device directly. Tap Advanced >
Surveillance > MJPEG server.
To Next Page
Loading...
