E16 Door Phone Administrator Guide
Parameter Set-up:
•
Specific Port: select the specific ports from 1-65535 so that only the data packet
from the specific port can be captured. You can leave the field blank by default.
•
PCAP: go to the start tab and Stop tab to capture a certain range of data packets
before going to the Export tab to export the data packets to your Local PC.
•
PCAP Auto Refresh: select Enable or Disable to turn on or turn off the PCAP auto
fresh function. If you set it as Enable then the PCAP will continue to capture data
packets even after the data packets reached their 1M maximum in capacity. If you
set it as Disable the PCAP will stop data packet capturing when the data packet
captured reached the maximum capturing capacity of 1MB.
15.3
Remote Debug Server
You can set up a remote debug server so that Akuvox technical team will be able to obtain
the log remotely for debugging. To configure the server, go to System > Maintenance >
Remote Debug Server.
Parameter Set-up:
•
Enabled: enable the debug server before debugging.
•
Connect Status: display the remote debug server connection status.
To Next Page
Loading...
