E16 Door Phone Administrator Guide
Note
•
Please refer to the chapter Configure DTMF Data Transmission forthe
specific DTMF code setting.
•
Intercom devices involved must be consistent in the DTMF type
otherwise DTMF code cannot be applied.
•
Name: enter the name for the Reception icon on the homescreen.
•
Number: enter the SIP/IP number to be called after pressing the Reception icon for
the door access.
11.11
Unlock by DTMF Code
DTMF codes can be configured on the door phone web interface and set up identical
DTMF codes on the corresponding intercom devices such as the indoor monitor, which
allows residents to enter the DTMF code on the soft keypad or press the DTMF code
attached to unlock tab on the screen to unlock the door for visitors etc., during a call. To
do the extra DTMF configuration on the web interface, you can go to Account > Advanced
> DTMF interface.
Parameter Set-up:
•
Type: select DTMF type among five options: Inband, RFC2833, Info+Inband, and
Info+RFC2833 according to your need.
•
How to Notify DTMF: select among four options: Disable, DTMF, DTMF-Relay, and
Telephone-Event according to your need.
•
DTMF Payload: select the payload 96-127 for data transmission identification.
To Next Page
Loading...
