E16 Door Phone Administrator Guide
Parameter Set-up:
•
Mode: select either Disabled Mode or Wrist Mode for temperature measurement
according to your need. The device can be installed with a digital forehead
temperature detector therefore you can are required to set the mode properly
according to your application.
•
Mask Detection: select Disable if you want to turn off the mask detection. Select Set
mask-wearing as mandatory and the device will check if the visitor is wearing a
mask or not while reminding the visitor with the announcement Please wear a mask.
Select Display mask-wearing prompt and the device will display the mask-wearing
prompt only without making the mask-wearing mandatory. A warning alarm will be
triggered when the body temperature measured is detected higher than the defined
normal body temperature.
•
Normal Body Temperature: set the body temperature to the predefined body
temperature as the measuring basis in either Fahrenheit or Celsius. For example, if
you set the temperature at 37.3 degrees celsius as the normal temperature, then any
body temperature measured higher than 37.3 degrees celsius will be deemed as an
abnormal temperature, while the temperature is lower than 34 degrees celsius will be
deemed as low body temperature.
•
Low Temperature: set the low temperature.
•
Action For Abnormal Body Temperature: if you select Access Denied then anyone
who is detected with abnormal body temperature will be denied the door access. If
To Next Page
Loading...
