Akuvox R20A Series - LED Display Status

Single Tenant Door Phone
AKUVOX SMART INTERCOM www.akuvox.com
12
Note:
 Start Time and End Time will not be displayed unless you select
Specfic Time for your LED mode.
7.2. LED Display Status
LED display adjustment is used to display the light changes of call button in
the six status - normal(idle), offline, calling, talking and receiving a call. and
the user can also verify the current mode of the device through the LED
status. To setup on device web Intercom > LED Setting interface.
The default LED Display Status:
LED Status
Description
Blue
Always on
Normal status
Flashing
Calling
Red
Flashing
Network is unavailable
Green
Always
on
Talking on a call
Flashing
Receiving a call
Pink
Flashing
Upgrading
Parameters Set-up:
 State: there is five states: Normal, Offline, Calling, Talking and
Receiving.