Single Tenant Door Phone
AKUVOX SMART INTERCOM www.akuvox.com
closed(NC) If the relay status is high, then it is in Normally Open
status(NO).
Note:
Only the external devices connected to the relay switch needs to
be powered by power adapters as relay switch does not supply
power.
Note:
If DTMF mode is set as “1 Digit DTMF” , you cannot edit DTMF
code in 2~4 Digits DTMF field. And if you set DTMF mode from
2-4 in 2~4 Digits DTMF” field, you can not edit DTMF code in 1
Digit DTMF field.
13.2.Select Chime Bell Relay
This function is used to trigger a relay when call out. It is often used in some
specific scenario.
Parameters Set-up:
Apply Setting to: there are three options can be chosen “None” “Relay A”
“Relay B”. which one is chosen, it will be triggered after press call button.
13.3.Web Relay Setting
In additional to the relay that is connected to the door phone, you can also
To Next Page
Loading...
Need help?
General
