Single Tenant Door Phone
AKUVOX SMART INTERCOM www.akuvox.com
16.2.1. Configure Motion Detection
You can turn on the motion detection and set up the motion detection
interval on the device.
Parameter Set-up:
Motion Detection: To enable or disable Motion Detection.
Time: set the time interval for the motion detection. If you set the default
time interval as “10” Sec, then the motion detection time span will be 10
seconds.Assuming that we set the time interval as “10” then, and the first
movement captured can be seen as start point of the motion detection,
and if the movement continues through 7 seconds of the 10 second
interval, then the alarm will be triggered at 7 seconds ( the first trigger
point) and motion detection action can be triggered (sending out
notification) any where between 7-10 seconds once the movement is
detected.“10” Sec interval is a complete cycle of the motion detection
before it starts another cycle of the same time interval. To be more
specific, the first trigger point can be calculated as the “ Time interval
minus three”
To Next Page
Loading...
Need help?
General
