Single Tenant Door Phone
AKUVOX SMART INTERCOM www.akuvox.com
7.LED Setting
7.1. Infrared LED Setting
Infrared LED is applied in the dark environment in which a resident might not
be able to see a visitor clearly via the video from the door phone. If the
infrared LED is turned off, the door phone will turn to night mode so that you
can have a clear view of the visitor.
Parameter Set-up:
LED Type：select”Auto” if you want the Infrared LED light to be turned on
automatically according to the setting. select “Aways ON” to enable the
Infrared LED light to stay on permanently. select “Aways OFF” to turn off
the Infrared LED light. LED mode is set “Always OFF” by default. select
“Schedule” to turn on the infrared LED according to the time schedule.
Min/Max Photoresistor ： set the minimum and maximum photoresistor
value based on the current actual photo-resistor value detected to
control the ON-OFF of the LED light. You can set the maximum
photoresistor value for the IR LED to be turned on and the minimum value
for it to be turned off. While the default Minimum and maximum
photoresistor value is from “0” minimum to “1000” maximum
respectively.
Start Time: set the start time for the infrared LED to be turned on.
End Time: set the end time for the infrared LED to be turned off.
To Next Page
Loading...
Need help?
General
