Akuvox R20A Series User Manual

Single Tenant Door Phone
AKUVOX SMART INTERCOM www.akuvox.com
49
15.2.Configure Access Card for Door Unlock
You can manage the card number and corresponding parameters on web
Intercom > Card Setting interface.
Parameters Set-up:
 IC/ID Enable: to active the IC or ID card type.
 Card Status: select “Car Issuing” in the field before adding the RFID card
and change the status back to “Normal” after the card is added.
 IC key DoorNum: select the relay switch available for the RIFD card door
access.

Akuvox R20A Series Specifications

General

Installation	Wall-mounted
Protection level	IP65
RS485	Yes
Camera	2MP
Audio	Built-in microphone and speaker
Network	10/100Mbps Ethernet
Protocols	SIP, RTSP
Power	PoE or 12V DC