Alcatel-Lucent 4035 - Transmission of a Calibrated Cut-Off (Flash)

The attendant presses the key to move onto the second screen:
Pressing the Pulse key displays: DTMF and exits from the Service feature.
The attendant dials the additional digits to be sent. These digits are displayed on the right of
the screen. If the number dialled is greater than 10 digits, each subsequent digit is displayed in
the 10
th
position.
Pressing the SERVICE fixed key followed by the Pulse key exits the feature and displays the
following screen:
4.8 Transmission of a calibrated cut-off (flash)
Note:
This feature is not available on an ISDN trunk group.
This feature lets the attendant activate the following types of operations at the remote PBX
end:
- call-back by a register for acceptance of the dialing by a suffix,
- a service operation (remote attendant intervention).
The attendant makes an outgoing call:
- by prefix or access code,
- by speed dialing,
- by programmed key.
Chapter
4
$$ '!
4-8
          