MPLS Commands
Page 122 7210 SAS M, T, X, R6, Mxp MPLS Configuration
Guide
push
Syntax no push label
push label nexthop ip-address
Context config>router>mpls>static-lsp
Description This command specifies the label to be pushed on the label stack and the next hop IP address for the
static LSP.
The no form of this command removes the association of the label to push for the static LSP.
Parameters label — The label to push on the label stack. Label values 16 through 1,048,575 are defined as
follows:
Label values 16 through 31 are 7750 SR reserved.
Label values 32 through 1,023 are available for static assignment.
Label values 1,024 through 2,047 are reserved for future use.
Label values 2,048 through 18,431 are statically assigned for services.
Label values 28,672 through 131,071 are dynamically assigned for both MPLS and services.
Label values 131,072 through 1,048,575 are reserved for future use.
Values 16 — 1048575
nexthop ip-address — This command specifies the IP address of the next hop towards the LSP
egress router. If an ARP entry for the next hop exists, then the static LSP is marked operational.
If ARP entry does not exist, software sets the operational status of the static LSP to down and
continues to ARP for the configured nexthop. Software continuously tries to ARP for the configured
nexthop at a fixed interval.
shutdown
Syntax [no] shutdown
Context config>router>mpls>static-lsp
Description This command is used to administratively disable the static LSP.
The no form of this command administratively enables the staticLSP.
Default shutdown
To Next Page
Loading...
Need help?
General
