Alcatel-Lucent 7210 SAS M User Manual

Show Commands
Page 180 7210 SAS M, T, X, R6, Mxp MPLS Configura-
tion Guide
lsp
Syntax lsp lsp-name [status {up|down}] [from ip-address | to ip-address] [detail]
lsp {transit | terminate} [status {up | down}] [from ip-address | to ip-address | lsp-name
name] [detail]
lsp count
lsp lsp-name activepath
lsp lsp-name path [path-name] [status {up |down}] [detail]
lsp [lsp-name] path [path-name] mbb
Context show>router>mpls
Description This command displays LSP details.
Parameters lsp lsp-name — The name of the LSP used in the path.
status up — Displays an LSP that is operationally up.
status down — Displays an LSP that is operationally down.
from ip-address — Displays the IP address of the ingress router for the LSP.
to ip-address — Displays the IP address of the egress router for the LSP.
transit — Displays the number of static LSPs that transit through the router.
terminate — Displays the number of static LSPs that terminate at the router.
lsp count
— Displays the total number of LSPs.
activepath — Displays the present path being used to forward traffic.
mbb — Displays make-before-break (MBB) information.
detail — Displays detailed information.
Output MPLS LSP Output — The following table describes MPLS LSP output fields.
Label Description
LSP Name
The name of the LSP used in the path.
To
The system IP address of the egress router for the LSP.
Adm State
Down — The path is administratively disabled.
Up — The path is administratively enabled.
Oper State
Down — The path is operationally down.
Up — The path is operationally up.
Oper State
Down — The path is operationally down.
Up — The path is operationally up.
LSPs
The total number of LSPs configured.
From
The IP address of the ingress router for the LSP.

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English