MPLS and RSVP
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide Page 187
LSP Number : 2 Dst Tunnel Num: 32
Forward Path configuration
In Label : 2080 Out Label : 2081
Out Interface : CtoB_1 Next Hop Addr : n/a
Reverse Path configuration
In Label : 2081 Out Label : 2080
Out Interface : CtoA_1 Next Hop Addr : n/a
===============================================================================
A:mplstp-dutC#
srlg-database
Syntax srlg-database [router-id ip-address] [interface ip-address]
Context show>router>mpls
Description This command displays MPLS SRLG database information.
Parameters router-id ip-address — Specifies a 32-bit integer uniquely identifying the router in the Autonomous
System. By convention to ensure uniqueness, this may default to the value of one of the router's
IPv4 host addresses, represented as a 32-bit unsigned integer, if IPv4 is configured on the router.
The router-id can be either the local one or some remote router.
interface ip-address — Specifies the IP address of the interface.
path
Syntax path [path-name] [lsp-binding]
Context show>router>mpls
Description This command displays MPLS paths.
Parameters path-name — The unique name label for the LSP path.
lsp-binding — Keyword to display binding information.
Output MPLS Path Output — The following table describes MPLS Path output fields.
Label Description
Path Name
The unique name label for the LSP path.
Adm
Down — The path is administratively disabled.
Up — The path is administratively enabled.
Hop Index
The value used to order the hops in a path.
To Next Page
Loading...
Need help?
General
