Alcatel-Lucent 7210 SAS M User Manual

Show Commands
Page 188 7210 SAS M, T, X, R6, Mxp MPLS Configura-
tion Guide
Sample Output
*A:SRU4>config>router>mpls# show router mpls path
===============================================================================
MPLS Path:
===============================================================================
Path Name Adm Hop Index IP Address Strict/Loose
-------------------------------------------------------------------------------
to_110_20_1_1 Up no hops n/a n/a
to_110_20_1_2 Up no hops n/a n/a
to_110_20_1_3 Up no hops n/a n/a
to_110_20_1_4 Up no hops n/a n/a
to_110_20_1_5 Up no hops n/a n/a
to_110_20_1_6 Up no hops n/a n/a
to_110_20_1_110 Up no hops n/a n/a
to_10_8_100_15 Up no hops n/a n/a
to_10_20_1_20 Up no hops n/a n/a
to_10_20_1_22 Up no hops n/a n/a
to_10_100_1_1 Up no hops n/a n/a
------------------------------------------------------------------------------
Paths : 11
===============================================================================
*A:SRU4>config>router>mpls#
IP Address
The IP address of the hop that the LSP should traverse on the way to
the egress router.
Strict/Loose
Strict — The LSP must take a direct path from the previous hop
router to the next router.
Loose — The route taken by the LSP from the previous hop to the
next hop can traverse through other routers.
LSP Name
The name of the LSP used in the path.
Binding
Primary — The preferred path for the LSP.
Secondary — The standby path for the LSP.
Paths
Total number of paths configured.
Label Description (Continued)

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English