MPLS and RSVP
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide Page 203
Tools Commands
cspf
Syntax cspf to ip-addr [from ip-addr] [bandwidth bandwidth] [include-bitmap bitmap] [exclude-
bitmap bitmap] [hop-limit limit] [exclude-address excl-addr [excl-addr...(up to 8 max)]]
[use-te-metric] [strict-srlg] [srlggroup grp-id...(up to 8 max)] [skip-interface interface-
name]
Context tools>perform>router>mpls
Description This command computes a CSPF path with specified user constraints.
Default none
Parameters to ip-addr — Specify the destination IP address.
from ip-addr — Specify the originating IP address.
bandwidth bandwidth — Specifies the amount of bandwidth in mega-bits per second (Mbps) to be
reserved.
include-bitmap bitmap — Specifies to include a bit-map that specifies a list of admin groups that
should be included during setup.
exclude-bitmap bitmap — Specifies to exclude a bit-map that specifies a list of admin groups that
should be included during setup.
hop-limit limit — Specifies the total number of hops a detour LSP can take before merging back onto
the main LSP path.
exclude-address ip-addr — Specifies IP addresses, up to 8, that should be included during setup.
use-te-metric — Specifies the use of the traffic engineering metric used on the interface.
strict-srlg — Specifies whether to associate the LSP with a bypass or signal a detour if a bypass or
detour satisfies all other constraints except the SRLG constraints.
srlg-group grp-id — Specifies up to 8 Shared Risk Link Groups (SRLGs). An SRLG group
represents a set of interfaces which could be subject to the same failures or defects and therefore,
share the same risk of failing.
Values 0 — 4294967295
skip-interface interface-name — Specifies an interface name that should be skipped during setup.
To Next Page