Alcatel-Lucent 7210 SAS M - Page 213

MPLS and RSVP
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide Page 213
xc
Syntax xc [detail]
no xc
Context debug>router>mpls>event
Description This command debugs cross connect events.
The no form of the command disables the debugging.
Parameters detail — Displays detailed information about cross connect events.
rsvp
Syntax [lsp lsp-name] [sender source-address] [endpoint endpoint-address] [tunnel-id tunnel-id]
[lsp-id lsp-id] [interface ip-int-name]
no rsvp
Context debug>router
Description This command enables and configures debugging for RSVP.
Parameters lsp lsp-name — Name that identifies the LSP. The LSP name can be up to 32 characters long and
must be unique.
sender source-address — The system IP address of the sender.
endpoint endpoint-address — The far-end system IP address.
tunnel-id tunnel-id — The RSVP tunnel ID.
Values 0 — 4294967295
lsp-id lsp-id — The LSP ID.
Values 1 — 65535
interface ip-int-name — The interface name. The interface name can be up to 32 characters long and
must be unique. If the string contains special characters (#, $, spaces, etc.), the entire string must
be enclosed within double quotes.
nbr
Syntax nbr [detail]
no nbr
Context debug>router>rsvp>event
Description This command debugs neighbor events.
The no form of the command disables the debugging.
Parameters detail — Displays detailed information about neighbor events.