Alcatel-Lucent 7210 SAS M - Page 312

Show Commands
Page 312 7210 SAS M, T, X, R6, Mxp MPLS Configuration
Guide
Debug Commands
The following output shows debug LDP configurations discussed in this section.
A:ALA-12# debug router ldp peer 10.10.10.104
A:ALA-12>debug>router>ldp# show debug ldp
debug
router "Base"
ldp peer 10.10.10.104
event
bindings
messages
exit
packet
hello
init
keepalive
label
exit
exit
exit
exit
A:ALA-12>debug>router>ldp#
ldp
ldp
Syntax [no] ldp
Context debug>router
Description Use this command to configure LDP debugging.
interface
Syntax [no] interface interface-name
Context debug>router>ldp
Description Use this command for debugging an LDP interface.
Parameters interface-name — The name of an existing interface.
peer
Syntax [no] peer ip-address
Context debug>router>ldp
Description Use this command for debugging an LDP peer.