Alcatel-Lucent 7210 SAS M - Page 313

LDP
7210 SAS M, T, X, R6, Mxp MPLS Configuration Guide Page 313
Parameters ip-address — The IP address of the LDP peer.
event
Syntax [no] event
Context debug>router>ldp>peer
Description This command configures debugging for specific LDP events.
bindings
Syntax [no] bindings
Context debug>router>ldp>peer>event
Description This command displays debugging information about addresses and label bindings learned from LDP
peers for LDP bindings.
The no form of the command disables the debugging output.
messages
Syntax [no] messages
Context debug>router>ldp>peer>event
Description This command displays specific information (for example, message type, source, and destination)
regarding LDP messages sent to and received from LDP peers.
The no form of the command disables debugging output for LDP messages.
packet
Syntax packet [detail]
no packet
Context debug>router>ldp>peer
Description This command enables debugging for specific LDP packets.
The no form of the command disables the debugging output.
Parameters detail — Displays detailed information.