Alcatel-Lucent 7450 - Page 125

CLI Usage
Basic System Configuration Guide 125
Received : Pkts - 0 Octets - 0
===============================================================================
A:ALA-12>monitor>router>mpls#
lsp-egress-statistics
Syntax lsp-egress-stats lsp-name [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>router>mpls
Description This command displays egress statistics for LSP interfaces at the configured interval until the
configured count is reached.
Default no lsp-egress-statistics
Parameters repeat repeat — Specifies how many times the command is repeated.
Values 10
Values 1 to 999
interval seconds — Specifies the interval for each display, in seconds.
Values 10
Values 3 to 60
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
Output
Sample Output
B:Dut-C-cpm2# monitor router mpls lsp-egress-stats sample repeat 3 interval 10
absolute
===============================================================================
Monitor egress statistics for MPLS LSP "sample"
-------------------------------------------------------------------------------
At time t = 0 sec (Base Statistics)
-------------------------------------------------------------------------------
LSP Name : sample
-------------------------------------------------------------------------------
Collect Stats : Enabled Accting Plcy. : 5
Adm State : Up PSB Match : True
FC BE
InProf Pkts : 0 OutProf Pkts : 551
InProf Octets : 0 OutProf Octets: 560918
FC L2
InProf Pkts : 0 OutProf Pkts : 551
InProf Octets : 0 OutProf Octets: 560918
FC AF
InProf Pkts : 551 OutProf Pkts : 0