Alcatel-Lucent 7450 - High Availability (Redundancy) Commands

System Management
Basic System Configuration Guide 333
— ptp
— ql-override {prs | stu | st2 | tnc | st3e | st3 | eec1 | sec | prc | ssu-a | ssu-b | eec2}
—no ql-override
— [no] shutdown
— ref1
— bits-interface-type {ds1 [{esf | sf}] | e1 [{pcm30crc | pcm31crc}]}
—no bits-interface-type
— ql-override {prs | stu | st2 | tnc | st3e | st3 | eec1 | sec | prc | ssu-a | ssu-b | eec2}
—no ql-override
— [no] shutdown
— source-bits slot/mda
— no source-bits
— source-port port-id
—no source-port
— ssm-bit sa-bit
— ref2
— bits-interface-type {ds1 [{esf | sf}] | e1 [{pcm30crc | pcm31crc}]}
—no bits-interface-type
— ql-override {prs | stu | st2 | tnc | st3e | st3 | eec1 | sec | prc | ssu-a | ssu-b | eec2}
—no ql-override
— [no] shutdown
— source-bits slot/mda
— no source-bits
— source-port port-id
—no source-port
— ssm-bit sa-bit
— [no] ql-selection
— [no] revert
High Availability (Redundancy) Commands
root
—admin
— redundancy
— display-config [detail |index]
— redundancy
— force-switchover [now] [ignore-status]
— rollback-sync
— synchronize {boot-env | config}
config
—system
— switchover-exec file-url
—no switchover-exec
— redundancy
— mgmt-ethernet
— redundancy
— multi-chassis
— [no] peer ip-address
— authentication-key[authentication-key | hash-key] [hash | hash2]
—no authentication-key