System Command Reference
398 Basic System Configuration Guide
System Synchronization Configuration Commands
sync-if-timing
Syntax sync-if-timing
Context config>system>
Description This command creates or edits the context to create or modify timing reference parameters.
Default Disabled
abort
Syntax abort
Context config>system>sync-if-timing
Description This command is required to discard changes that have been made to the synchronous interface timing
configuration during a session.
Default No default
begin
Syntax begin
Context config>system>sync-if-timing
Description This command is required in order to enter the mode to create or edit the system synchronous interface
timing configuration.
Default No default
bits
Syntax bits
Context config>system>sync-if-timing
Description This command enables the context to configure parameters for the Building Integrated Timing Supply
(BITS). The settings specified under this context apply to both the BITS input and BITS output ports
and to both the bits1 and bits2 ports on the 7750 SR-c4.
To Next Page
Loading...
