Common Configuration Tasks
202 Basic System Configuration Guide
The most basic BOF configuration should have the following:
• Primary address
• Primary image location
• Primary configuration location
Following is a sample of a basic BOF configuration.
A:SR-45# show bof
===============================================================================
BOF (Memory)
===============================================================================
primary-image cf3:/4.0.R20
primary-config cf3:/ospf_default.cfg
address 138.120.189.53/24 active
static-route 138.120.0.0/16 next-hop 138.120.189.1
static-route 172.0.0.0/8 next-hop 138.120.189.1
autonegotiate
duplexfull
speed100
wait3
persiston
console-speed 115200
===============================================================================
A:SR-45#
Common Configuration Tasks
The following sections are basic system tasks that must be performed.
• Searching for the BOF
→ Accessing the CLI
- Console Connection
• Configuring BOF Parameters
For details about hardware installation and initial router connections, refer to the specific
router hardware installation guide.
Searching for the BOF
The BOF should be on the same drive as the boot loader file. If the system cannot load or
cannot find the BOF then the system checks whether the boot sequence was manually
interrupted. The system prompts for a different image and configuration location.
To Next Page
Loading...
