File System Management
Basic System Configuration Guide 181
Parameters cflash-id — Specifies the compact flash slot ID to be shut down or enabled. If cflash-id is
specified, the drive is shut down or enabled. If no cflash-id is specified, the drive referred to
by the current working directory is assumed. If a slot number is not specified, then the active
CPM/CFM is assumed.
Default The current compact flash device
Values cf1:, cf1-A:, cf1-B:, cf2:, cf2-A:, cf2-B:, cf3:, cf3-A:, cf3-B:
active — If active is selected, then all drives on the active CPM are shutdown or enabled.
standby — If standby is selected, then all drives on the standby CPM are shutdown or enabled.
When both active and standby keywords are specified, then all drives on both CPM are
shutdown.
File Commands
attrib
Syntax attrib [+r | -r] file-url
attrib
Context file
Description This command sets or clears/resets the read-only attribute for a file in the local file system. To list all
files and their current attributes enter attrib or attrib x where x is either the filename or a wildcard (*).
When an attrib command is entered to list a specific file or all files in a directory, the file’s attributes
are displayed with or without an “R” preceding the filename. The “R” implies that the +r is set and that
the file is read-only. Files without the “R” designation implies that the -r is set and that the file is read-
write-all. For example:
ALA-1>file cf3:\ # attrib
cf3:\bootlog.txt
cf3:\bof.cfg
cf3:\boot.ldr
cf3:\sr1.cfg
cf3:\test
cf3:\bootlog_prev.txt
cf3:\BOF.SAV
Parameters file-url — The URL for the local file.
Values
local-url | remote-url 255 chars max
local-url [cflash-id/][file-path]
remote-url [ftp://login:pswd@remote-locn/][file-path]
cf1:,cf1-A:,cf1-B:,cf2:,cf2-A:,cf2-B:,cf3:,cf3-A:,cf3-B:
To Next Page
Loading...
