System Management
Basic System Configuration Guide 309
===================================================
Synchronize Mode : Configuration
Synchronize Status : No synchronization
Last Config Sync Time : 2006/06/27 09:17:15
Last Boot Env Sync Time : 2006/06/24 07:16:37
===================================================
A:ALA-12>config>system#
Configuring Multi-Chassis Redundancy for LAG
When configuring associated LAG ID parameters, the LAG must be in access mode and
LACP must be enabled.
Use the CLI syntax displayed below to configure multi-chassis redundancy features.
CLI Syntax: config>redundancy
multi-chassis
peer ip-address
authentication-key [authentication-key | hash-
key] [hash | hash2]
description description-string
mc-lag
hold-on-neighbor-failure duration
keep-alive-interval interval
lag lag-id lacp-key admin-key system-id
system-id [remote-lag lag-id] system-
priority system-priority
no shutdown
no shutdown
source-address ip-address
sync
igmp
igmp-snooping
pim-snooping [sap]
port [port-id | lag-id] [sync-tag sync-
tag]
range encap-range sync-tag sync-tag
no shutdown
srrp
sub-mgmt
Example: config>redundancy#
config>redundancy# multi-chassis
config>redundancy>multi-chassis# peer 10.10.10.2 create
To Next Page
Loading...
