CLI Usage
Basic System Configuration Guide 19
CLI Monitor Commands
Monitor commands display specified statistical information related to the monitor subject
(such as filter, port, QoS, router, service, and VRRP) at a configurable interval until a count
is reached. The CLI monitor commands are found in the root>monitor context of the CLI
tree.
The monitor command output displays a snapshot of the current statistics. The output display
refreshes with subsequent statistical information at each configured interval and is displayed
as a delta to the previous display.
The <Ctrl-c> keystroke interrupts a monitoring process. Monitor command configurations
cannot be saved. You must enter the command for each monitoring session. Note that if the
maximum limits are configured, you can monitor the statistical information for a maximum
of 60 * 999 sec ~ 1000 minutes.
The CLI monitor command contexts are listed in Table 5.
reduced-prompt Configures the maximum number of higher-level CLI context
nodes to display by name in the CLI prompt for the current CLI
session.
saved-ind-prompt Saves the indicator in the prompt.
suggest-internal-
objects
Enables the suggestion of internally created objects while auto
completing.
terminal Configures the terminal screen length for the current CLI session.
time-display Specifies whether time should be displayed in local time or UTC.
Table 4: CLI Environment Commands (Continued)
Command Description
Table 5: CLI Monitor Command Contexts
Command Description
card Enables monitoring of ingress FP queue groups.
ccag Enables CCAG port monitoring for traffic statistics. This
command is supported on the 7450 ESS and 7750 SR; additional
restrictions may apply.
cpm-filter Monitor command output for CPM filters.
To Next Page
Loading...
