Alcatel-Lucent 7450 - Show Command Output and Console Messages

Common Configuration Tasks
316 Basic System Configuration Guide
CLI Syntax: config>system
boot-bad-exec file-url
boot-good-exec file-url
Example: config>system# boot-bad-exec ftp://
test:test@192.168.xx.xxx/./
fail.cfg
config>system# boot-good-exec ftp://
test:test@192.168.xx.xxx/./
ok.cfg
The following example displays the command output:
A:ALA-12>config>system# info
#------------------------------------------
echo "System Configuration"
#------------------------------------------
name "ALA-12"
contact "Fred Information Technology"
location "Bldg.1-floor 2-Room 201"
clli-code "abcdefg1234"
coordinates "N 45 58 23, W 34 56 12"
config-backup 7
boot-good-exec "ftp://test:test@192.168.xx.xxx/./ok.cfg"
boot-bad-exec "ftp://test:test@192.168.xx.xxx/./fail.cfg"
power-supply 1 dc
power-supply 2 dc
lacp-system-priority 1
sync-if-timing
begin
ref-order ref1 ref2 bits
..
----------------------------------------------
A:ALA-12>config>system#
Show Command Output and Console Messages
The show>system>information command displays the current value of the bad/good exec
URLs and indicates whether a post-boot configuration extension file was executed when the
system was booted. If an extension file was executed, the show>system>information
command also indicates if it completed successfully or not.
The following is an example for the 7750 SR:
ALA-12>config>system# show system information
===============================================================================
System Information
===============================================================================
System Name : ALA-12
System Contact : Fred Information Technology