EasyManua.ls Logo

Alcatel-Lucent 7450 - Satellite Client Port Association; Software Repositories; Administrative Tasks; Configuring the Chassis Mode

Alcatel-Lucent 7450
576 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
System Management
Basic System Configuration Guide 281
Satellite Client Port Association
Use the following format to reference Ethernet satellite client ports:
port esat- sat-id/1/sat-port
Software Repositories
The software repositories define the locations from where the host can obtain software for
subcomponents including Ethernet satellites. The software repository is also used to upgrade
an existing subcomponent by changing the location of the image to be served to the remote
device. The software repositories are not used for management of the host router software,
which is managed using the standard procedures described in the Release Notes.
Each software repository supports up to three locations to search for the software. A location
may be a URL or a directory on a compact flash. When an upgrade operation is initiated, each
of the three locations is checked in sequence to locate the required software. The upgrade
operation will fail if the software is not located in any of the configured locations. The
satellite booting operation will also fail if the software cannot be located.
Administrative Tasks
This section contains information to perform administrative tasks.
Configuring the Chassis Mode
Saving Configurations
Specifying Post-Boot Configuration Files
Network Timing
Power Supplies
Configuring the Chassis Mode
Depending on the 7450 ESS and 7750 SR chassis type and IOM type, the following modes
can be configured:

Table of Contents

Other manuals for Alcatel-Lucent 7450

Related product manuals