System Timing
318 Basic System Configuration Guide
The system configuration is missing or incomplete.
MAJOR: CLI #1008 The SNMP daemon is disabled.
If desired, enable SNMP with the ’config>system>snmp no shutdown’ command.
Attempting to exec configuration failure extension file:
’ftp://test:test@192.168.xx.xxx/./fail.cfg’ ...
Config fail extension
Enabling SNMP daemon
MAJOR: CLI #1009 An error occurred while processing a CLI command -
File ftp://test:test@192.168.xx.xxx/./fail.cfg, Line 5: Command "abc log" failed.
TiMOS-B-x.0.Rx both/hops ALCATEL Copyright (c) 2000-2009 Alcatel-Lucent.
All rights reserved. All use subject to applicable license agreements.
Built on Thu Nov 207 19:19:11 PST 2008 by builder in /rel5x.0/b1/Rx/panos/main
Login:
System Timing
In the event that network timing is required for the synchronous interfaces in the router, a
timing subsystem is utilized to provide a clock to all synchronous interfaces within the
system.
This section describes the commands used to configure and control the timing subsystem.
Use the CLI syntax displayed below to:
• Edit Mode
• Configuring Timing References
• Using the Revert Command
• Other Editing Commands
• Forcing a Specific Reference
Edit Mode
To enter the mode to edit timing references, you must enter the begin keyword at the
config>system>sync-if-timing# prompt.
Use the following CLI syntax to enter the edit mode:
CLI Syntax: config>system>sync-if-timing
begin
To Next Page
Loading...
