System Management
Basic System Configuration Guide 429
Context configure>system>ptp>peer
Description This command disables or enables a specific PTP peer. Shutting down a peer sends cancel unicast
negotiation messages on any established unicast sessions. When shutdown, all received packets from
the peer are ignored.
If the clock-type is ordinary slave or boundary, and PTP is no shutdown, the last enabled peer cannot
be shutdown. This prevents the user from having PTP enabled without any peer configured & enabled
Default no shutdown
shutdown
Syntax [no] shutdown
Context configure>system>ptp>port
Description This command disables or enables a specific PTP port. When shutdown, all PTP Ethernet messages
are dropped on the IOM They will not be counted in the PTP message statistics. No PTP packets are
transmitted by the node toward this port.
If the clock-type is ordinary slave or boundary, and PTP is no shutdown, the last enabled port or peer
cannot be shutdown. This prevents the user from having PTP enabled without any means to
synchronize the local clock to a parent clock.
Default no shutdown
Redundancy Commands
bgp-multi-homing
Syntax bgp-multi-homing
Context config>redundancy
Description This command configures BGP multi-homing parameters.
boot-timer
Syntax boot-timer seconds
no boot-timer
Context config>redundancy>bgp-multi-homing
To Next Page
Loading...
