System Command Reference
430 Basic System Configuration Guide
Description This command configures the time the service manger waits after a node reboot before running the DF
election algorithm. The boot-timer value should be configured to allow for the BGP sessions to come
up and for the NLRI information to be refreshed/exchanged.
The no form of the command reverts the default.
Default no boot-timer
Parameters seconds — Specifies the BGP multi-homing boot-timer in seconds.
Values 1 to 100
cert-sync
Syntax [no] cert-sync
Context admin>redundancy
Description This command automatically synchronizes the certificate/CRL/key when importing or generating (for
the key). Also if a new CF card is inserted into slot3 into the backup CPM, the system will sync the
whole system-pki directory from the active CPM. This command applies only to the 7450 ESS and
7750 SR.
Default enabled
force-switchover
Syntax force-switchover [now] [ignore-status]
Context admin>redundancy
Description This command forces a switchover to the standby CPM card. The primary CPM reloads its software
image and becomes the secondary CPM.
Parameters now — Forces the switchover to the redundant CPM card immediately.
ignore-status — Forces a switchover despite any diagnostics or conditions on the standby. For
the 7950 XRS, this is true even if the standby cannot reach the extension CPMs on the
extension chassis of an XRS-40 via its local CPM interconnect ports).
mgmt-ethernet
Syntax mgmt-ethernet [revert seconds]
no mgmt-ethernet
Context configure>redundancy
To Next Page
Loading...
