Alcatel-Lucent 7450 - The CLI Command Prompt

The CLI Command Prompt
22 Basic System Configuration Guide
| +---autonomous-system <autonomous-system>
| | no autonomous-system
| +---bfd
| | +---abort
| | +---begin
| | +---bfd-template <[32 chars max]>
|||nobfd-template <[32 chars max]>
| | | +---echo-receive <milli-seconds>
||||noecho-receive
| | | +---multiplier <[3..20]>
||||nomultiplier
| | | +---no receive-interval
||||receive-interval <milli-seconds>
| | | +---no transmit-interval
||||transmit-interval <milli-seconds>
| | | +---no type
||||type{cpm-np}
| | +---commit
| +---bgp
||nobgp
| | +---add-paths
|||noadd-paths
| | | +---ipv4 send <send-limit>
||||ipv4send <send-limit> receive [none]
||||noipv4
| | | +---no ipv6
||||ipv6send <send-limit>
||||ipv6send <send-limit> receive [none]
| | | +---no vpn-ipv4
||||vpn-ipv4 send <send-limit>
||||vpn-ipv4 send <send-limit> receive [none]
| | | +---no vpn-ipv6
||||vpn-ipv6 send <send-limit>
||||vpn-ipv6 send <send-limit> receive [none]
| | +---advertise-external [ipv4] [ipv6]
|||noadvertise-external [ipv4] [ipv6]
| | +---advertise-inactive
|||noadvertise-inactive
| | +---aggregator-id-zero
|||noaggregator-id-zero
| | +---auth-keychain <name>
| | +---authentication-key <authentication-key|hash-key> [hash|hash2]
The CLI Command Prompt
By default, the CLI command prompt indicates the device being accessed and the current CLI
context. For example, the prompt: A:ALA-1>config>router>if# indicates the active context,
the user is on the device with hostname ALA-1 in the configure>router>interface context.
In the prompt, the separator used between contexts is the “>” symbol.