Alcatel-Lucent 7450 - Page 21

CLI Usage
Basic System Configuration Guide 21
The tree and tree detail system commands are useful when searching for a command in a
lower-level context.
The following example shows a partial list of the tree and tree detail command output on a
7750 SR router.
*A:cses-E11>config# tree
+---router
| +---aggregate
| +---allow-icmp-redirect
| +---allow-icmp6-redirect
| +---autonomous-system
| +---bfd
| | +---abort
| | +---begin
| | +---bfd-template
| | | +---echo-receive
| | | +---multiplier
| | | +---receive-interval
| | | +---transmit-interval
| | | +---type
| | +---commit
| +---bgp
| | +---add-paths
| | | +---ipv4
| | | +---ipv6
| | | +---vpn-ipv4
| | | +---vpn-ipv6
| | +---advertise-external
| | +---advertise-inactive
| | +---aggregator-id-zero
| | +---auth-keychain
| | +---authentication-key
| | +---backup-path
| | +---best-path-selection
| | | +---always-compare-med
| | | +---as-path-ignore
| | | +---deterministic-med
| | | +---ignore-nh-metric
| | | +---ignore-router-id
| | +---bfd-enable
| | +---cluster
*A:cses-E11>config# tree detail
...
+---router [<router-name>]
| +---no aggregate <ip-prefix/ip-prefix-length>
| | aggregate <ip-prefix/ip-prefix-length> [summary-only] [as-set]
[aggregator <as-number:ip-address>] [black-hole [generate-icmp]]
[community <comm-id>]
| | aggregate <ip-prefix/ip-prefix-length> [summary-only] [as-set]
[aggregator <as-number:ip-address>] [community <comm-id>] [indirect
<ip-address>]
| +---allow-icmp-redirect
| | no allow-icmp-redirect
| +---allow-icmp6-redirect
| | no allow-icmp6-redirect