BOF Configuration Command Reference
214 Basic System Configuration Guide
Parameters seconds — The time to pause at the start of the boot process, in seconds.
Values 1 to10
Console Port Configuration
console-speed
Syntax console-speed baud-rate
no console-speed
Context bof
Description This command configures the console port baud rate.
When this command is issued while editing the BOF file used for the most recent boot, both the BOF
file and the active configuration are changed immediately.
The no form of the command reverts to the default value.
Default 115200 — console configured for 115,200 bps operation
Parameters baud-rate — The console port baud rate, expressed as a decimal integer.
Values 9600, 19200, 38400, 57600, 115200
Image and Configuration Management
persist
Syntax persist {on | off}
Context bof
Description This command specifies whether the system will preserve system indexes when a save command is
executed. During a subsequent boot, the index file is read along with the configuration file. As a result,
a number of system indexes are preserved between reboots, including the interface index, LSP IDs,
path IDs, etc. This reduces resynchronizations of the Network Management System (NMS) with the
affected network element.
In the event that persist is on and the reboot with the appropriate index file fails, SNMP is operationally
shut down to prevent the management system from accessing and possibly synchronizing with a
partially booted or incomplete network element. To enable SNMP access, enter the
config>system>snmp>no shutdown command.
To Next Page
Loading...
