Common Configuration Tasks
306 Basic System Configuration Guide
*A:SR-3>config>system>cron#
ANCP Enhancements
Persistency is available for subscriber’s ANCP attributes and is stored on the on-board
compact flash card. ANCP data will stay persistence during an ISSU as well as nodal reboots.
During recovery, ANCP attributes are first restored fully from the persistence file, and
incoming ANCP sessions are temporarily on hold. Afterwards, new ANCP data can overwrite
any existing values. This new data is then stored into the compact flash in preparation for the
next event.
Configuring Synchronization and Redundancy
• Configuring Persistence
• Configuring Synchronization
• Configuring Manual Synchronization
• Forcing a Switchover
• Configuring Synchronization Options
• Configuring Multi-Chassis Redundancy for LAG
Configuring Persistence
The following example displays subscriber management system persistence command usage
for the 7450 ESS and 7750 SR:
Example: config>system# persistence
config>system>persistence# subscriber-mgmt
config>system>persistence>sub-mgmt# description
"cf3:SubMgmt-Test"
config>system>persistence>sub-mgmt# location cf3:
config>system>persistence>sub-mgmt# exit
A:ALA-12>config>system>persistence# info
----------------------------------------------
subscriber-mgmt
description "cf3:SubMgmt-Test"
location cf1:
exit
----------------------------------------------
A:ALA-12>config>system>persistence#
To Next Page
Loading...
